How to Program Hex Files

February 2, 2026 ยท View on GitHub

  1. Set both switches/jumpers in dev mode position.
  2. Open STM32CubeProgrammer.
  3. Select the Disco board through the "External loaders" tab.
  4. ST-Link configuration: set mode to "Hot plug".
  5. Connect the board.
  6. From the "Erasing & programming" tab, select the Binary/STM32N6570-DK/x-cube-n6-camera-capture-front-dk.hex file.
  7. Wait for flashing to complete.

Board Selection Flash the Hex file