Speaker
May 23, 2018 ยท View on GitHub
Parts
Assembly
Cut off the connector and connect one wire from the mini speaker to pin 5 (C6) and the other to GND on the master side. Depending on your case and how you position it, it might be necessary to remove the cap of the speaker to make it fit. Secure it with some tape or glue so it doesn't short circuit anything.
Speaker (Left Hand)
Firmware
In QMK you need to enable audio AUDIO_ENABLE = yes and #define C6_AUDIO,
see Documentation: QMK Firmware - Audio.
You can't both have RBG Underglow and Audio enabled at
the same time since the firmware will be to large to fit in a Pro Micro.