Create a Security Group on AWS using the Command Line Interface
December 28, 2016 ยท View on GitHub
# Create a Security Group on AWS using the Command Line Interface
-
Set your AWS region to the region you wish to use. This tutorial uses
us-west-2.me@LOCAL: (master)$ aws configure set region us-west-2 -
Verify that you are configured for the correct region.
me@LOCAL: (master)$ aws configure list Name Value Type Location ---- ----- ---- -------- profile <not set> None None access_key ****************BOTO shared-credentials-file secret_key ****************s32/ shared-credentials-file region us-west-2 config-file ~/.aws/config -
Create the security group
aws ec2 create-security-group \ --group-name jupyter \ --description 'sc for running jupyter notebook server' -
Update the Inbound Rules for the Security Group
jupyter. Make sure you enter all three of these commands.-
for ssh
aws ec2 authorize-security-group-ingress \ --group-name jupyter \ --protocol tcp \ --port 22 \ --cidr 0.0.0.0/0 -
for docker
aws ec2 authorize-security-group-ingress \ --group-name jupyter \ --protocol tcp \ --port 2376 \ --cidr 0.0.0.0/0 -
for jupyter
aws ec2 authorize-security-group-ingress \ --group-name jupyter \ --protocol tcp \ --port 8888 \ --cidr 0.0.0.0/0
-
-
Select the region you would like to use. These instructions will use US-West-2.
-
Navigate to EC2.
-
Select Security Groups.
-
Create a New Security Group.
-
Describe the new security group with the following values:
- Security group name:
jupyter - Description:
security group for running jupyter notebook - VPC: MAKE SURE TO USE DEFAULT VALUE
- Security group name:
-
Create the following Security Group Rules
Type Protocol Port Range Source Custom TCP Rule TCP 8888 Custom // 0.0.0.0/0 SSH TCP 22 Custom // 0.0.0.0/0 Custom TCP Rule TCP 2376 Custom // 0.0.0.0/0 